Samsung EC-NV7ZZBBJ/AS, EC-NV7ZZBBC/DE, EC-NV7ZZBBA/FR manual Connectinga to a Power Source

Connectinga to a Power Source

Number of images and battery life : Using the SLB-0837

		Still image			Movie
Battery life			Number of images		Recording time
Approx. 75 MIN			Approx. 150		Approx. 80 MIN
	Using the fully charged battery,				Using the fully charged
	Auto mode, 7M image size,				battery
Based	Fine image quality, Shot to shot interval			Based	640X480 image size
on the	: 30Sec.			on the	30fps frame rate
following	Changing the zoom position between			following
shooting	the Wide and the Tele after every shot.			shooting
conditions	Using the flash on every second shot.			conditions
	Using the camera for 5 minutes and
	then Powering it off for 1 minute.

The specified shooting capacity can be affected by using the OPS function. These figures are measured under Samsung’s standard conditions and shooting conditions and may vary depending on the user's methods.

You can charge the rechargeable battery (SLB-0837) by using an SAC-45 KIT. The SAC-45 consists of the AC adapter (SAC-45) and the USB cable (SUC-C2). When the AC adapter and the USB cable are assembled, it can be used as an AC cable.

Using the SAC-45 as an AC charger

: Insert the AC adapter into the USB connector. When the AC adapter is inserted, it can be used as an AC charger.

Using the SAC-45 as an USB cable

: Remove the AC adapter from the USB connector. You can transmit data with a PC (p.71) or charge the battery.

INFORMATION

Important information about battery usage.

When the camera is not used, turn off the camera power.

Please remove the battery if the camera will not be used for long periods. Battery can lose power over time and are prone to leaking if kept inside the camera.

Low temperatures (below 0°C) can affect the performance of the battery and you may experience reduced battery life.

Battery will usually recover at normal temperatures.

During extended use of the camera, the camera body may become warm. This is perfectly normal.

CAUTION

In the following cases, the battery may not be charged.

When using the USB cable that was not supplied with this camera. Use the supplied USB cable.

When using a USB hub. Connect the camera to the PC directly.

When other USB devices are connected to the PC. Disconnect the other USB devices.

When the USB is connected to the USB port located on the front of the computer. Use the USB located on the back of the computer.

If the USB port of the PC doesn't meet the Power output standard (5V, 500mA), the camera may not be charged.

11