About the battery, Battery speciﬁcations

About the battery

Use only Samsung-approved batteries.

Mode	SLB-10A

Type	Lithium-ion battery

Cell capacity	1050 mAh

Voltage	3.7 V

Charging time	Approx. 150 min
(when the camera is switched off)

Average time	Test conditions
Average time	(when the battery is fully charged)
	(when the battery is fully charged)
	Take photos under the following
	conditions: in the 2 mode, 10M
	resolution, Fine quality, OIS on.
Approx. 120 min	1. Set the ﬂash option to	(Fill In), take a
Approx. 120 min	single shot, and zoom in or out.
Photos (Approx. 240	single shot, and zoom in or out.
Photos (Approx. 240	2. Set the ﬂash option to	(Off), take a
photos)	single shot, and zoom in or out.

3.Perform steps 1 and 2 for 30 seconds and repeat for 5 minutes. Then turn off the camera for 1 minute.

4.Repeat steps 1 to 3.

Videos	Approx. 120 min	Record videos at 640x480 resolution and
Videos	Approx. 120 min	30 fps.
		30 fps.

Average time		Test conditions
Average time		(when the battery is fully charged)
		(when the battery is fully charged)

MP3	Approx. 310 min	Play ﬁles with the screen turned off.

PMP	Approx. 230 min	Play ﬁles with normal playback.

The ﬁgures above are measured by Samsung’s standards and may differ depending on usage.

Notes about charging the battery

•If the indicator light is off, make sure that the battery is inserted correctly.

•Turn off your camera when charging.

•Turn on your camera after charging the battery for more than 10 minutes.

•Using ﬂash or recording videos uses up the battery quickly. Charge the battery until the indicator light turns green.

•If the indicator light blinks in red or is off, reconnect the cable or remove the battery and insert it again.

•If you charge the battery when it is warm, the indicator light may turn orange. Charging will start when the battery cools down.

Notes about charging with a computer connected

•Use the provided USB cable only.

•The battery may not be charged when:

-you use a USB hub

-other USB devices are connected to your computer

-you connect the cable to the port on the front side of your computer

-the USB port of your computer does not support the Power output standard (5 V, 500 mA)