39
Tip:
To launch the Contacts menu using a voice command — In standby
mode, press and hold until the phone prompts, “Say a
command.” Say “Go to Contacts” into the microphone.
2. Select the desired option.
Tip:
You can also press the keypad number key that corresponds to the
menu option number.
Finding a Contacts Entry
Voice Method
Use the Voice SVC Lookup command to view contact information
for any named contact stored in your Contacts list by saying the
name.
Note:
The Lookup command shows the requested contact information in the
display but does not dial any phone numbers for the contact.
To look up information for a specific contact:
1. In standby mode, press and hold to launch Voice
SVC.
“Say a Command” appears in the display and is
pronounced through the speaker.
2. Say “Lookup”.
Voice SVC prompts you to “Say the name.”
3. Speak clearly and say the full name of the person you want
to call, exactly as it is entered in your Contacts list.
•
If VoiceSignal recognizes the name you said, the contact
information for that name appears in the display.
•
If VoiceSignal does not recognize the name you said, a choice list of
up to three names appears in the display, and VoiceSignal prompts
you with “
Did you say?
” followed by the first name on the list.
4. Say “Yes” to confirm the name or “No” to hear the next
name, or use the keypad to select the correct name from
the list. (See “Choice Lists” on page 71, for more
information.)
•
To say the name again, press the
Repeat
soft key.
•
To exit VoiceSignal without dialing, press .
5. The contact information for the name you selected appears
in the display.
•
To dial the number associated with the name, press .
•
To erase this entry from your Contacts list, press the
Erase
soft key.
•
To add or change information for this entry, press
EDIT
().
•
For more options, press the
Options
soft key and the following
options pop-up in the display:
–
Send Txt Msg
r560.book Page 39 Tuesday, June 16, 2009 1:04 PM