BN68-00678A-01_002~23 2004.4.28 6:12 PM Page 12
Wall Installation Instructions
Fixing the PDP panel to the wall attachment panel bracket
1 Remove the screws from the back of the PDP.
2 Connect insulation holders to screws (see the illustration below).
• If you are uncertain about installation, hire a specialist to install the wall mount bracket.
• Be sure to check that the insulation holders are completely secured on both the left and right side after hanging the PDP on the wall mount bracket.
•Be careful to avoid getting your fingers caught during installation.
•Make sure the wall attachment panels are tightened. Otherwise the PDP may fall.
Tighten the screws of the insulation
3 holders to the back of the PDP.
Put the 4 insulation holders on the PDP
4 in the grooves of the wall mount bracket and pull down on the PDP (Œ) to secure it to the wall mount bracket (´). Tighten the screws as shown (ˇ) so that the PDP cannot be separated from wall mount bracket.
PDP panel | ˇ |
Œ
´
Wall attachment panel | Wall |
bracket |
|
Note
• A 5 inch gap is needed between the back of the Plasma TV and the wall.
12
