Onkyo S5100 First Time Setup—Continued, Error Messages, To Retry the Automatic Speaker Setup

First Time Setup—Continued

3	Press [ENTER].
	The automatic speaker setup starts.
	You can cancel the automatic speaker setup at
	any point in this procedure simply by discon-
	necting the setup microphone.

A test tone is output by each speaker in turn, as the Audyssey 2EQ function determines which speakers are connected. This takes a few min- utes.

Note:

•Quiet the room as much as possible. Back- ground noise can disrupt the room measure- ments. Close windows, silence cell phones, televisions, radios, air conditioners, fluores- cent lights, home appliances, light dimmers, or other devices, and refrain from talking.

4	When the following display appears,
	move the speaker setup microphone to
	measurement point 2 (page 42), and
	then press [ENTER].

Audyssey 2EQ performs more measurements. This takes a few minutes.

5	When the following display appears,
	move the speaker setup microphone to
	measurement point 3 (page 42), and
	then press [ENTER].

Audyssey 2EQ performs more measurements. This takes a few minutes.

When the measurements are complete, the results are calculated and saved automatically.

6	When the automatic speaker setup is
	complete, disconnect the speaker setup
	microphone.

Note:

•When the automatic speaker setup is complete, the Equalizer Settings (page 81) will be set to “Audyssey.”

Error Messages

While the automatic speaker setup is in progress, one of the following error messages may appear:

Ambient noise is too high

This message appears if there’s too much background noise and the measurements cannot be performed prop- erly. Remove the source of the noise and try again.

Speaker Detect Errors

This message appears if one of the speaker-related errors below occurs.

•One of the front speakers has not been detected.

•One of the surround speakers has not been detected.

•The surround back speakers have been detected but the surround speakers haven’t.

•The right surround back speaker has been detected but the left surround back speaker hasn’t.

•The number of speakers detected on the second or third measurement was different to the number detected on the first measurement.

Write Error

This message appears if saving fails.

❑Matching Error

This message appears if a speaker that was detected during the 1st measurement is not detected during the 2nd or 3rd measurements. If this message appears, check your speaker connections, and then try again.

To Retry the Automatic Speaker Setup

Press the [ENTER] button.

Make sure speakers that cannot be detected are connected properly.

Changing the Speaker Settings Manually

If you wish to make changes to the settings found during the automatic speaker setup, follow the directions on pages 77–81.

43