First Time
Component Video Input Setup
If you connect a video component to a COMPONENT VIDEO IN, you must assign that input to an input selector. For example, if you connect your DVD player to COMPONENT VIDEO IN 2, you must assign COM- PONENT VIDEO IN 2 to the DVD input selector.
By default, the DVD input selector is assigned to COM- PONENT VIDEO IN 1, and all of the other input selec- tors (i.e., VCR/DVR, CBL/SAT, AUX) are assigned to the “- -
1
2
3
4
Press the [RECEIVER] button, followed by the [SETUP] button.
Use the Up and Down []/[ ] buttons to select “2.Component,” and then press [ENTER].
Use the Up and Down []/[ ] buttons to select an input selec- tor, and use the Left and Right []/[ ] buttons to select:
IN1: Select if the video component is connected to COMPO-
NENT VIDEO IN 1.
IN2: Select if the video component is connected to COMPO-
NENT VIDEO IN 2.
No: Select if you’re not using the
COMPONENT VIDEO OUT.
Press the [SETUP] button.
Setup closes.
Note:
•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.
45