Adjusting the Listening Modes
Using the Audio Adjust Settings
With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.
1 | Press the [RECEIVER] button fol- |
| |
| lowed by the [SETUP] button. |
2 | Use the Up and Down [ ]/[ ] |
| buttons to select “6.Audio |
Adjust,” and then press [ENTER].
3 | Use the Left and Right [ ]/[ ] |
| buttons to change the setting. |
Press the Down [ ] button to select the next setting.
Repeat this step for the other settings.
4 | Press the [SETUP] button. |
| |
| Setup closes. |
The Audio Adjust settings are explained below.
Multiplex/Mono Settings
Multiplex
■Input (Mux)
This setting determines which channel of a stereo multi- plex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.
Main: The main channel is output (default). Sub: The sub channel is output.
M/S: Both the main and sub channels are out- put.
Mono
■Input (Mono)
This setting determines which channel is output when the Mono listening mode is used with a stereo source.
L+R: Both the left and right channels are output (default).
L:Only the left channel is output.
R:Only the right channel is output.
PLIIx/Neo:6 Settings
PLIIx Music (2 ch Input)
These settings apply to only
If you’re not using any surround back speakers, these settings apply to Dolby Pro Logic II, not Dolby Pro Logic IIx.
■Panorama
With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx Music listening mode.
On: Panorama function on.
Off: Panorama function off (default).
■Dimension
With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic IIx Music listening mode. It can be adjusted from
If the stereo image feels too wide, or there’s too much surround sound, move the sound field forward to improve the balance. Conversely, if the stereo image feels like it’s in mono, or there’s not enough surround sound, move it backward.
■Center Width
With this setting, you can adjust the width of the sound from the center speaker when using the Dolby Pro Logic IIx Music listening mode. Normally, if you’re using a center speaker, the center channel sound is output by only the center speaker. (If you’re not using a center speaker, the center channel sound will be distributed to the front left and right speakers to create a phantom cen- ter). This setting controls the front left, right, and center mix, allowing you to adjust the weight of the center channel sound. It can be adjusted from 0 to 7. The default value is 3.
74