Connections

Connecting to the Network

Wireless Network

You can connect to the network with a Wireless IP sharer.

1.A wireless AP/IP router is required to make a wireless network connection. Connect the wireless LAN adapter to the Wireless LAN Adapter on the rear panel of the product.

2.Set the network options. (See page 39)

Broadband service

Wireless IP sharer

PC

Wireless LAN Adapter

(not included)

Networking with PC for AllShare function

(See pages 60~61)

✎NOTE

You must upgrade the software to use this function.

This product is compatible with only Samsung's Wireless LAN Adapter. (not supplied) (Model name: WIS09ABGN).

-The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer for purchasing.

You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the wireless network.)

Wireless LAN, in its nature, may cause interference, depending on the use condition (AP performance, distance, obstacle, interference by other radio devices, etc).

Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.

When applying the security key for the AP (wireless IP sharer), only the following is supported.

1)Authentication Mode : WEP, WPAPSK, WPA2PSK

2)Encryption Type : WEP, AES

For the AllShare function, a PC must be connected in the network as shown in the figure.

Connecting the FM Antenna

FM Antenna (supplied) 1. Connect the FM antenna supplied to the FM Antenna Jack.

2. Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.

✎NOTE

This product does not receive AM broadcasts.

28 English