Checking the Signal Information
You can get information about the signal status.
1.Press the MENU button to display the menu.
Press the ▲ or ▼ button to select "Digital Menu", then press the ENTER/OK button.
2.Press the ▲ or ▼ button to select "Setup", then press the ENTER/OK button.
3.Press the ▲ or ▼ button to select "System", then press the ENTER/OK button.
4.Press the ▲ or ▼ button to select "Signal Information", then press the ENTER/OK button.
5.Press the EXIT button to exit.
If the signal status is poor, the "No signal." message is displayed.
Signal Information | ||
Service: ? |
|
|
Service ID:0000 |
|
|
Multiplex: ? (TSID 0000, ONID 0000) | ||
Network: ? (ID 0000) |
| |
Bit error level: | 10 |
|
Signal Strength: | 0 |
|
Move | Enter | Return |
Return |
|
|
Upgrading the Software
To keep your product
It will automatically detect these signals and display the software upgrade banner. You are given the option to install the upgrade.
1.Press the MENU button to display the menu.
Press the ▲ or ▼ button to select "Digital Menu", then press the ENTER/OK button.
2.Press the ▲ or ▼ button to select "Setup", then press the ENTER/OK button.
3.Press the ▲ or ▼ button to select "System", then press the ENTER/OK button.
4.Press the ▲ or ▼ button to select "Software Upgrade", then press the ENTER/OK button.
5.Press the ▲ or ▼ button to select “Software Infomation”,
“Manual Upgrade” or “Satandby Mode upgrade”.
Press the ENTER/OK button.
| System |
|
Product Information | | |
Signal Information |
| |
Software Upgrade |
| |
Common Interface |
|
|
Reset |
| |
Move | Enter | Return |
Software Upgrade
Software Information | |
Manual Upgrade | |
Standby Mode upgrade : On | |
Move 
Enter 
Return
♦Software Inforamtion
Press the ENTER/OK button, then the current software version is shown. To display the software version information, press the ENTER/OK button again.
To switch to an alternative version, press the red button.
Press the blue button to reset, activate the upgrade and restart.
♦Manual Upgrade
Press the ENTER/OK button to search for new software from the currently broadcasting channels.
♦Standby Mode Upgrade : On / Off
Press the ENTER/OK button. To continue software upgrade with master power on, Select On by pressing the ▲ or ▼ button. 45 minutes after entering standby mode, a manual upgrade is automatically conducted. Since the power of the unit is turned on internally, the screen may be on slightly for the LCD product. This phenomenon may continue for more than 1 hour until the software upgrade is completed.
6.Press the EXIT button to exit.
English - 38
