Chapter 5. Menu
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Anynet+ is a function that enables you to control all connected Samsung devices that support Anynet+ with your Samsung product remote. The Anynet+ system can be used only with Samsung devices that have the Anynet+ feature. To be sure your Samsung device has this feature, check if there is an Anynet+ logo on it.
•You can only control Anynet+ devices using the product remote control, not the buttons on the product.
•The product remote control may not work under certain conditions. If this occurs, reselect the Anynet+ device.
• Anynet+ works when the AV device supporting Anynet+ is in the standby or on status.
•While in PIP mode, Anynet+ functions only when an AV device is connected as the primary display. It does not work if the AV device is connected as a secondary display.
• Anynet+ supports up to 12 AV devices in total. Note that you can connect up to 3 devices of the same type.
71
Troubleshooting forAnynet+
Problem | Possible Solution | ||
|
|
|
|
Anynet+ does not | • Check if the device is an Anynet+ device. The Anynet+ | ||
work. | system supports Anynet+ devices only. | ||
| • Check if the Anynet+ device power cord is properly | ||
| connected. | ||
| • Check the Anynet+ device’s Video/Audio/HDMI cable | ||
| connections. | ||
| • Check whether Anynet+ | ||
| System menu. | ||
| • Check whether the remote control is Anynet+ | ||
| compatible. | ||
| • Anynet+ doesn’t work in certain situations. (initial | ||
| setup) | ||
| • If you have removed and then reconnected the HDMI | ||
| cable, please make sure to search devices again or turn | ||
| your product off and on again. | ||
| • Check if the Anynet+ function of the Anynet device is | ||
| set on. | ||
I want to start | • Check if the Anynet+ device is properly connected to | ||
Anynet+. | the product and check if the Anynet+ | ||
| to On in the System menu. | ||
I want to exit Anynet+. | • Press the |
| button on the product remote control |
SOURCE | |||
| and select a non- Anynet+ device. | ||
The message | • You cannot use the remote control when you are | ||
“Disconnecting | configuring Anynet+ or switching to a view mode. | ||
Anynet+ device ...” | • Use the remote control after the product has | ||
appears on the screen. | completed Anynet+ configuration or has finished | ||
| switching to Anynet+. | ||
|
|
|
|