6 MASTERCONSOLE II USER MANUAL
h. To change the channel ID display position: Move to ID and press <Enter>. Then press
the <Ç>, <È>, <Å>, and <Æ> keys to move the menu vertically and horizontally to the
desired position. Then press <Esc> or <Enter>.
i. To turn PowerSave On/Off (default is OFF): Move to Green Mode and press the
<Ç>/<È> keys to toggle. To change the PowerSave delay time (default is 15 minutes):
Move to the next field and type a number from 01 to 99, or press the <Ç>/<È> keys to
change the interval (in minutes) of inactivity (no keyboard or mouse operation) after
which the video signal will be cut off from the monitor. This will allow a properly equipped
monitor to enter low-energy mode.
j. To select Previous Channel Toggle (default is <Caps Lock>). This feature enables the
user to toggle between the previous and current selected channel. Press F4 to display
the Configuration menu and move the cursor to the Previous Channel Key. Use the <->
or <¯> keys to select the key, <Caps Lock>, <Scroll Lock>, <Num Lock>, left <Shift>,
or left <Alt> to be used. This feature enables the user to switch back to a previous
channel by pressing the selected key twice rapidly. There is no need to activate the OSUI.
Note: Select a previous channel key that is not being used as the current hot key
activator.
4. To exit the Configuration Menu: Press an appropriate Menu F key to go to another menu, or
press <Esc> to exit on-screen user interface and return to normal computer operation. Any
changes made to the Configuration Menu are automatically saved.
You may assign meaningful names to quickly and easily identify and select connected computers.
By default, the channel name is PC00aa (where aa is the channel ID number) and the Channel-
Specific Scan Rate is 3 seconds.
1. Activate On-Screen User Interface.
2. Press <F3> to access the Edit Names and Scan Rate Menu.
Figure 12 Edit Names and Scan Rate Menu (One-Tier)
3. Use the <Tab>, <Shift+Tab> or <Ç>/<È> keys to move the cursor to the line you want to
edit. Use <Å>/<Æ> to move within a line.
a. To change the Name: Type up to 8 characters (no spaces).
b. To change the Channel-Specific Scan Rate (default is 3 seconds): Type a number from
00 to 99 (seconds). When the AutoScan Mode in the Configuration Menu is set to
Individual, these Channel-Specific Scan Rates are enabled. If the AutoScan mode is set
to Global, the global value will be used.
4. When you move to a different page or exit this Menu, you are prompted to save your changes.
Press <Y> to save.
5. To exit the Edit Names and Scan Rate Menu: Press any Menu F key to go to another menu,
or press <Esc> to go to the Selection Menu.