34
Using "PCoIP"
2
2 Using "PCoIP"
2.4.4 Configuration Window
The Configuration option on the Administrative Web Interface and OSD lets you configure various
settings for the device.
The tabs in the Configuration window are:
Each tab has the following buttons: OK, Cancel, and Apply. These buttons allow the administrator to
accept or cancel the changes made.
The OSD configuration options are a subset of the options available in the Administrative Web Interface.
To make changes to the configuration settings, you will need an administrator password. You do not
need a password to view the Diagnostic and Information menus. Applicable only when the Password
item is available.

Network Tab

You can configure the host and client network settings from the Initial Setup page or Network page.
After you update the parameters on this page, click Apply to save your changes.
The Network parameters can also be configured using the Administrative Web Interface.
Figure 2-5: Network Configuration
zEnable DHCP
When Enable DHCP is enabled, the device will contact a DHCP server to be assigned an IP
address, subnet mask, gateway IP address and DNS servers. When disabled, the device requires
these parameters to be set manually.
zNetwork zIPv6 zLabel
zDiscovery zSession zLanguage
zOSD zDisplay zReset