36
Using "PCoIP"
2
2 Using "PCoIP"
You should always set the Ethernet Mode to Auto and only use 10 Mbps Full Duplex or 100
Mbps Full Duplex when the other network equipment (i.e., switch) is also configured to operate at
10 Mbps full-duplex or 100 Mbps full-duplex. An improperly configured Ethernet Mode may
result in the network operating at half-duplex which is not supported by the PCoIP protocol. The
session will be severely degraded and eventually dropped.
IPv6 Tab
The IPv6 page lets you enable IPv6 for PCoIP devices connected to your IPv6 network.
zIPv6 is not currently supported by VMware View.
zWhen you make a change to one of the settings on this page, you must reboot your device for the
change to take effect.
Figure 2-6: IPv6 Configuration
zEnable IPv6
Enable this field to enable IPv6 for your PCoIP devices.
zLink Local Address
This field is automatically populated.
zGateway
Enter the gateway address.
zEnable DHCPv6
Enable this field to set up Dynamic Host Configuration Protocol version 6 (DHCPv6) for your device.
zPrimary DNS
The primary DNS IP address of the device. If DHCPv6 is enabled, this field is automatically populated
by the DHCPv6 server.