35
Using "PCoIP"
2
2 Using "PCoIP"
zIP Address
The IP address of the device. If DHCP is disabled, you must set this field to a valid IP address. If
DHCP is enabled, you cannot edit this field.
zSubnet Mask
The subnet mask of the device. If DHCP is disabled, you must set this field to a valid subnet mask. If
DHCP is enabled, you cannot edit this field.
It is possible to configure an illegal IP address/subnet mask combination (e.g., invalid mask)
making the device unreachable. Ensure you set the subnet mask properly.
zGateway
The gateway IP address of the device. If DHCP is disabled, this field is required. If DHCP is enabled,
you cannot edit this field.
zPrimary DNS Server
The primary DNS IP address of the device. This field is optional. If the DNS server IP address is
configured using the Connection Manager, the address may be set as an FQDN instead of an IP
address.
zSecondary DNS Server
The secondary DNS IP address of the device. This field is optional. If the DNS server IP address is
configured using the Connection Manager, the address may be set as an FQDN instead of an IP
address.
zDomain Name
The domain name used (e.g., 'domain.local'). This field is optional. This field specifies the host or
domain of the client.
zFQDN
The Fully Qualified Domain Name for the host or client. The default value is pcoip-host-<MAC> or
pcoipportal-<MAC> where <MAC> is the MAC address of the host or client. The domain name is
appended if used (e.g., pcoip-host-<MAC>.domain.local). This field is read-only on this page.
zEthernet Mode
Lets you configure the Ethernet mode of the host or client as:
Auto
100 Mbps Full-Duplex
10 Mbps Full-Duplex
When you choose 10 Mbps Full Duplex or 100 Mbps Full Duplex and then click Apply, a warning
message will appear.
"Warning: When Auto-Negotiation is disabled on the PCoIP device, it must also be disabled on the
switch. Additionally, the PCoIP device and switch must be configured to use the same speed and
duplex parameters. Different parameters may result in a loss of network connectivity. Are you sure
you want to continue?"
Click OK to change the parameter.