Samsung HCN553W manual Rear Panel Jacks Depending on the model, Antenna terminals Video Input jack

Y O U R N E W T V

Rear Panel Jacks (Depending on the model)

Use the rear panel jacks to connect an A/V component that will be connected continu- ously, such as a VCR or a DVD player.

Because there are two sets of input jacks, you can connect two different A/V components (i.e., a VCR and a DVD, 2 VCRs, etc.)

For more information on connecting equipment, see pages 2.1 – 2.10.

Œ ANTENNA terminals ˆ S-VIDEO INPUT jack

Two independent cables or antennas can be connected to these terminals. Use ANT-A and ANT-B terminals to receive a signal from VHF/ UHF antennas or your cable system.

Use the ANT-A OUT terminal to send the signal being received by the ANT-A terminal out to another component (such as a Cable Set Top Box). The PIP channel can be received only when

a signal source is connected to ANT-A.

´AUDIO-VIDEO MONITOR OUTPUT jacks

Connect to the audio/video input jacks of a recording VCR.

Note: The monitor out does not operate in DVD or DTV mode.

ˇVIDEO INPUT jacks

Connect to the video output jacks of VCRs, DVD players and similar devices (Two sets are available: Video1 and Video2).

¨AUDIO INPUT jacks

Connect to the audio output jacks of VCRs, DVD players and similar devices.

Connect to an S-VHS VCR or DVD player.

ØCOMPONENT 1(480i, 480p, 1080i) AUDIO/VIDEO INPUT jacks

Connect a source that outputs 480i/480p/1080i Y,PB and PR signals, such as a DVD (or DTV Set-Top Box.

∏DIGITAL INPUT (Digital Visual Interface) jack

Receives the digital video signals from a set top box. (The DVI jack is not available on PCN5425R.)

”COMPONENT 2, 3(480p, 1080i) AUDIO/VIDEO INPUT jacks

Connect a source that outputs 480p/1080i Y, PB and PR signals, such as a DTV Set-Top Box. (Component3 jacks ; Depending on the model)

’DVI AUDIO INPUT jacks

Receives the digital audio signals from a set top box.

CHAPTER ONE: YOUR NEW TV 1.4