•Ice is made in cubes. When you select “Crushed”, the ice maker grinds the ice cubes into crushed ice.
•When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced.
•The ice cubes generated by the rapid ice making process will look white, which indicates they were generated normally.
•As the ice maker in the refrigerator room makes ice cubes even faster, move the ice cubes from the refrigerator ice bin to the freezer ice bin if you need more ice cubes.
•If ice doesn’t come out, pull out the ice bucket and press the test button located on the right side of ice maker. See the illustration below.
•Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice may jam the bucket.
Making Ice• To fill the ice bucket to maximum capacity after installation, follow these steps:
1.Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
check the water level
Test button
2.Dispense 4 to 6 ice cubes into the glass.
3.After 8, and then 16 hours, dispense a full
glass of ice.
•To test the ice maker, press the Test button on the ice maker. You will hear the refrigerator chime
•The chime sounds automatically again to let you know the ice maker is working well.
28_ operating
If you want to remove the ice cubes CAUTION without using the ice bucket, please turn
the ice maker off and remove the ice maker’s front cover from the ice maker. Note that the ice cubes in the ice maker can spill out over the drawer.
Do not put food in the ice bucket. CAUTION If you store food in the ice bucket, the
food can strike the ice maker when you open or close the door, causing damage to the ice maker.
Note that the ice cubes in the ice bucket CAUTION may spill out over the drawer when you
remove the ice bucket from the drawer. If this occurs, be sure to clear the ice cubes that spilled out of the drawer.
If a power failure occurs, ice cubes may CAUTION melt, and then freeze together when
the power comes back on, causing the dispenser to stop working.
To prevent this problem, after a power failure, pull out the ice bucket and discard the residual ice or water.
If you use all the ice at once, you must repeat ice making Steps 2 and 3, left. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production.
2016. 3. 24. �� 8:21 |