Connecting the water line to the refrigerator
1.Remove the cap from the water line on the unit and insert the compression nut of the water line into the water line on the unit.
2.Connect the water line on the unit with the water line in the kit .
3.Tighten the compression nut onto the compression fitting. There should be no gaps between (A, B & C )
4.Turn water on and check for any leakage.
Only connect the water line to a drinkable water source. If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug,
Loosen a | Remove | |
cap | ||
|
Water Line from unit
No gap
Water Line from Kit
Before being used, the leakage in these CAUTION places should be examined.
• Samsung Warranty
does not cover
WATER LINE INSTALLATION.
• It will be done at customer’s charge
unless the retail price includes installation cost.
•Please contact Plumber or Authorized Installer for the installation if needed.
•If Water leakage occurs due to improper installation, Please contact installer.
22_ setting up
Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational.
1.Make sure your refrigerator is in an appropriate location with reasonable clearance between it and the wall. Refer to installation instructions in this manual.
2.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures you want.
4.After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the refrigerator after the temperature is sufficiently cool.
2016. 3. 24. �� 8:20 |