INSTALLING THE WATER DISPENSER LINE
A water dispenser with a fi lter is one of the helpful features on your new refrigerator. To help promote better health, the water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the ice maker to operate properly, a water pressure of 138 ~ 862 kPa is required. Under normal conditions, a 0.17 L cup can be
fi lled in about 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer.
We recommend using a water line installation kit that contains copper tubing and 6 mm compression nut.
Connecting to the water supply line
1.First, shut off the main water supply.
2. Locate the nearest cold water drinking line and | 01 |
install the pipe clamp and shut off valve. | |
Cold water line | SETTING |
| |
Pipe clamp | UP |
| |
Shut off valve |
|
3.Connect the water line installation kit to the shut off valve.
Cold water line 
Water line installation kit
Pipe clamp
Shut off valve 
Connecting the water supply line to the refrigerator.
There are several items that you need to purchase to complete this connection.
You may fi nd these items sold as a kit at your local hardware store.
Use Copper Tubing | Use Plastic Tubing | ||
• 6 mm copper tubing | • | 6 mm plastic tubing | |
• | 6 mm compression nut |
| → Molded end(Bulb) |
| (1pc) | • | 6 mm compression nut |
• | Ferrule (2pc) |
| (1pc) |
|
|
|
|
setting up _13
2012.6.15 7:47:54 PM |
