Checking the water dispenser line
A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in about 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Installing the water line
Connecting the water supply line to the refrigerator.
There are several items that you need to purchase to complete this connection.
You may find these items sold as a kit at your local hardware store.
Use Copper Tubing | Use Plastic Tubing | ||
|
|
|
|
• | ¼” copper tubing | • | ¼” plastic tubing |
• ¼” compression nut (1pc) |
| → Molded end(Bulb) | |
• | Ferrule (2pc) | • | ¼” compression nut (1pc) |
|
|
|
|
Refrigerator
Water line installation kits are available at extra cost from your dealer. We recommend using a water line installation kit that contains copper tubing
and ¼” compression nut.
Connecting to the water supply line
1. First, shut off the main water supply.
Compression Nut (1/4”)
(Assembled)
Ferrule (Not supplied)
Plastic Tubing (Assembled)
Compression Fitting (Assembled)
Molded end(Bulb)
Compression nut (B) (1/4”) (Not supplied)
2. Locate the
nearest cold | Cold water line | |
water drinking | Pipe clamp | |
line and install | ||
| ||
the pipe clamp |
| |
and shut off | Shut off valve | |
valve. | ||
|
3.Connect the water line installation kit to the shut off valve.
Cold water line
Water line installation kit Pipe clamp 
Shut off valve 
Copper tubing | or | Plastic tubing (B) |
(Not supplied) |
| (Not supplied) |
Household water supply line
1.Connect the household water line to the assembled compression fitting.
-If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on the copper tubing (not supplied) as shown.
-If you are using plastic tubing ( B ) , insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting.
Do not use without the molded end (Bulb) of caution the plastic tubing ( B ).
2.Tighten the compression nut ( B ) onto the compression fitting.
Do not
10_ setting up
