Samsung RFG28MERS1/HAC Using the Tilting Pocket, Removing the Freezer Accessories, Flex Zone

Rounded up while pressing the button

Button

Reassemble in the inverse order of the CAUTION disassembly. The

assembly is completed when you hear a “Click”.

4. Flex Zone

To remove the Flex Zone

– Pull the Flex door out to full extension. Lift the Flex Zone up, pulling it to your body with both hands.

To relocate the Flex Zone

– Open the Flex door to

full extension. Tilt the front of the Flex Zone up, place the back of the Flex Zone onto the rails, and then lower the front until the whole Zone rests on the rails.

When the Flex Zone or LED lighting are not working, check the connectors [ ( 1 ), ( 2 ) shown below] for cracks or leaks.

2

1

18_ operating

1.Refer to page 9 for disassembly instructions.

2.Open the cover housing with a flat-blade screwdriver.

USING THE TILTING POCKET

The Tilting Pocket can be used to store up to a 406mm pizza if you place it as shown in the illustration.

REMOVING THE FREEZER ACCESSORIES

1. Tilting Pocket

To remove - Pull the brackets upward until you hear a clicking sound and remove the pocket

To replace - Hook the ends of the pocket into both brackets ( 1 ) and push down until it locks into place.

1

2. Auto Pull out Drawer

To remove - Pull the drawer out to full extension. Tilt up rear of drawer and lift straight out.

To relocate - Place the drawer onto the rails by tilting it up. Lower the drawer into place until it is horizontal and slide the drawer in.

2

1

DA99-03404D-11.indb 18 2015. 5. 7. ￿￿ 8:10