COUPLER “A”
| TAP |
| LINE OUTLET |
SIDE OF | 90 degree |
PURIFIER |
|
CAUTION
PURIFIER WATER Insert Locking Clip After tube seated
WATER INLET | COUPLER |
SIDE OF PURIFIER | Locking Clip |
|
Replacement Instructions
1.Shut off water supply.
2.Note the Flow direction on the filter.
3.Insert water supply tube into the inlet side of the filter until the tube stop.
FLOW DIRECTION
WATER SUPPLY | PERMEAT |
INLET SIDE
Note : You must also ensure that the cut is square and not at any sort of angle as this could cause a leak
Remove any residual matter inside the purifier. (Model with the purifier)
- Open the main water tap to check whether water |
| |
is running through the water tube on the water |
| |
inlet side of the purifier. |
|
|
- If water does not come out through the line, |
| |
check whether the tap is open. |
| |
- Leave the tap open until clean water is running |
| |
out and any residual matter that built up during |
| |
manufacturing has been removed. | 01 | |
|
| |
OUTLET SIDE OF |
| SETTING |
PURIFIER | PURIFIER |
|
|
| |
WATER | WATER LINE | UP |
| ||
Attach the purifier lock-clip.
-Hold the purifier
Purifier
4.After inserting tube, put together the clip strongly. The Clip fix the tube.
5.Turn on the water and check for leaks. If leaks occur, repeat step 1,2,3,4. If leaks persist, discontinue use and call your supporting dealer.
6.Flush filter for 5 minutes before use.
Secure the purifier in position.
-Fix the purifier in position, as shown in the figure on the right.
WATER TUBE 
Purifier 
PURIFIER
setting up _13
2014. 7. 19. 8:41 |
