Re-attaching the Water Supply Lines

1.The Water Lines must be fully Inserted into the center of the transparent coupler to prevent water leakage from the dispenser.

2.Insert the 2 clips in the install pack as shown below, and then confirm that each clip holds the line firmly.

Center of Transparent coupler

Clip A (1/4”) (6.35 mm)

Make sure the color of the water lines

CAUTION match.

When the Freezer part is lower than the Fridge part.

Insert a flat-blade screwdriver into a slot on the Freezer Leg, then turn it clockwise.

When the Fridge part is lower than the Freezer part.

Insert a flat-blade screwdriver into a slot on the Fridge Leg, then turn it clockwise.

setting up

LEVELING THE REFRIGERATOR

Make sure the refrigerator is level so that you can make final adjustments.

Use a level to test if the refrigerator is level both side to side and back to front.

If the refrigerator is not level, you will not be able to get the doors perfectly even, which may cause moisture condensation and increased energy bills.

The front of the refrigerator is also adjustable.

Before levelling the refrigerator, remove the front leg cover.

Open both the freezer and refrigerator doors. Unscrew the three screws holding the front leg cover in place by turning them counter-clockwise. When the screws are loose, remove the front leg cover.

Screw

 

Driver

 

 

 

 

 

 

Leg

Refer to the next section for the best way to make very minor adjustments to the doors.

English - 21

DA68-02981C-00.indb 21

2014. 1. 28. �� 10:47