Samsung RS25H5223SL/ZA Installing the Water Dispenser Line, Connecting to the water supply line

INSTALLING THE WATER

DISPENSER LINE

A water dispenser is one of the helpful features on your new Samsung Refrigerator.

To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms.

You may need to purchase a water purifying system to do that.

The water line also connects to the ice maker. For the ice maker to operate properly, water pressure of 20 ~ 125 psi (138 ~ 862 kPa) is required.

If the refrigerator is installed in an area with low water pressure (below 20 psi), you can install a booster pump to compensate for the low pressure. After you have connected the water line, make sure the water storage tank inside the refrigerator

Connecting the water supply line to the refrigerator

There are several items that you need to purchase
to complete this connection.
You may find these items		sold as a kit at your local
hardware store.			up
Use Copper Tubing		Use Plastic Tubing
• 6.35 mm copper tubing		• 6.35 mm plastic tubing	setting
•	6.35 mm compression	→ Molded end (Bulb)
	nut (1pc)	• 6.35 mm compression
•	Ferrule (2pc)	nut (1pc)

Refrigerator

is properly filled.

To do this, press the water dispenser lever until

Compression

Plastic Tubing

(Supplied)

water runs from the water dispenser.

Water line installation kits are available at extra cost from your dealer.

We recommend using a water supply kit that contains copper tubing.

Connecting to the water supply line

1.First, shut off the main water supply line and turn the ice-maker off.

2.Locate the nearest cold water drinking water line.

3.Install the pipe clamp and shut off valve.

4.Connect the water line installation kit to the shut off valve.

Cold water line

Water lineinstallation kit Pipe clamp

Shut off valve

Nut (6.35 mm)

(Assembled) Compression Fitting (Assembled)

Ferrule	Bulb (B)
(Not supplied)

Compression nut (B) (6.35 mm) (Not supplied)

Copper tubing	or	Plastic tubing (B)
(Not supplied)		(Not supplied)

Household water line

1. Connect the household water line to the assembled compression fitting.

-- If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on the copper tubing (not supplied) as shown.

-- If you are using plastic tubing ( B ), insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting.

Do not use plastic tubing ( B ) without the CAUTION molded end (Bulb).

English - 23

DA68-02981C-00.indb 23 2014. 1. 28.

�� 10:47