4. Turn the cartridge knob clockwise to lock into place.
5. Press and hold Filter Reset on the feature panel for 3 seconds to reset the filter lifecycle. The filter indicator ( ) turns off.
6. When replacing is complete, flush 4 liters of water to remove impurities from the water line. See the Flushing section for more information.
NOTE
•A newly installed filter may cause the water dispenser to spurt water briefly. This is because air has entered the waterline.
•This replacement process may involve the refrigerator to drip water onto the floor. If this happens, wipe up with dry cloths.
Reverse osmosis water filtration system
The water pressure of the water supply system to a reverse osmosis water filtration system must be between 35 psi and 120 psi (241 kPa and 827 kPa).
The water pressure of the reverse osmosis water filtration system to the refrigerator’s cold water line must be at least 40 psi (276 kPa). If the water pressure is below the specified:
•Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.
•Refill the water tank in the reverse osmosis system with water.
•If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter.
For more information or servicing, contact a licensed plumbing professional.
Ordering a new filter
To purchase a new water filter, contact a local Samsung service centre.
Lamps and
Neither lamps nor the
Maintenance
English 59
|
| 7/17/2017 4:54:56 PM | |
|
| ||
|
|
|
|