Samsung RH58K6598SL/ES, RSA1ZTMG1/EUR, RSA1ZTMG1/XEF, RH62K6257SL/ES Initial settings, Final check

To connect the water filtering hose to the water line

a

A

a

B

Remove cap

a

03

1.	Loosen and remove the compression
	nut (a) from the water line of the
	refrigerator, and insert it to the water
	filtering hose.
2.	Tighten up the compression nut (a) to
	connect the water filtering hose and the
	water line.
3.	Open the main water valve and check
	for any leaks.
4.	If there are no leaks, dispense about a
	3 liters of water before actually using
	the refrigerator to remove impurities

A.Water Line from unit

B.Water Line from Kit

inside the water filtering system.

Installation

To repair the water line

CAUTION

The waterline must be repaired by a qualified professional. If you encounter a water leak, contact a local Samsung service centre or the installer of the waterline.

STEP  7  Initial settings

By completing the following steps, the refrigerator should be fully functioning.

1.Plug the power cord into the wall socket to turn the refrigerator on.

2.Open the door, and check if the interior light lights up.

3.Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be slightly chilled, and the motor will run smoothly.

4.Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready for use.

STEP  8  Final check

When installation is complete, confirm that:

•The refrigerator is plugged into an electrical outlet and grounded properly.

• The refrigerator is installed on a flat, level surface with a reasonable clearance from the wall or the cabinet.

•The refrigerator is level and is sitting firmly on the floor.

•The door opens and closes freely, and the interior light turns on automatically when you open the door.

English  29 

Untitled-28 29

7/17/2017 4:54:42 PM