Other issue

HDMI Black Level is not functioning properly on an HDMI device with YCbCr output.

This function is available only when a source device, such as a DVD player and STB, is connected to the product via an HDMI (RGB signal) cable.

The IR sensor is not functioning.

Make sure the sensor light turns on when a button is pressed on the remote control.

•• If the light does not turn on, turn the power switch off and then on again.

If the sensor light still does not turn on after the power switch is turned off and then on again, an internal jack may be disconnected.

Contact your nearest service center to have the product serviced.

In power-saving mode, when the input source is DisplayPort, PC display settings cannot be saved.

Go to System → Power Control and set Max. Power Saving to Off. Alternatively, configure the PC display output settings again. Ensure the set is turned on.

When booting the PC with the input source set to

Boot the PC when the set is turned on or when the input source is not DisplayPort.

DisplayPort, the BIOS and booting screens do not appear.

 

 

 

90