Connecting the Cables
1.Connect one end of the BNC cable to the VIDEO OUT.
2.Connect the other end of the BNC cable to the VIDEO IN of the monitor.
Video terminals on the back of the monitor
BNC cable
3.Plug in the power adapter. Use a "minus" screwdriver to connect one part of the power adapter, which consists of two lines, to the POWER terminal of the camera as follows :
POWER SELECTION switch underneath the power adapte
POWER SELECTION switch underneath the power adapte
4.Determine the type of power supply and set the POWER SELECTION switch accordingly. Next, plug the power adapter into a wall outlet.
The requirements for the power adapter for each model are as follows:
● | E | |
● |
| |
| DC12V 600mA |
|
5.If the camera operates normally, the following screen will be displayed for 5 seconds and then disappears.
| SAMSUNG | PROTOCOL |
|
|
| ||
| ADDRESS | 0 |
|
| TYPE |
| |
| BAUD RATE | 9600 |
|
| LENS | OK |
|
| ROM VER | 1.000 |
|
| EEP VER | 1.000 |
|
|
|
|
|
❖ROM VER and EEP VER may change without notice.
6.The requirements for RS485 control is as follows :
●Signaling Speed: 9600 bps
●Data Bit : 8 bits
●Stop Bit : 1 bit
●Parity Bit : none
13 | 14 |
