To connect Alarm OUT

installation & connection

To connect ALARM IN

1.Connect one end of the external device's signal line to a corresponding ALARM IN port of the monitor.

2.Connect the other end of the signal line to the earth-grounding [GND] port.

1.Connect one end of the external device's signal line to a corresponding ALARM OUT port of the monitor.

2.Connect the other end of the signal line to the common [COM] port.

To connect the controller

Connect an external controller or DVR to the camera, with which you can adjust the camera.

1.Connect the Rx+ pin of the camera to the Tx+ pin of the controller.

2.Connect the Rx- pin of the camera to the Tx- pin of the controller.

3.Connect the Tx+ pin of the camera to the Rx+ pin of the controller.

4.Connect the Tx- pin of the camera to the Rx- pin of the controller.

Rx Tx

18_ installation & connection

00890A-NA_SCC-C6453N-ENG.indb 18

2009-08-05 오후 3:03:

Page 18

Image 18

Samsung SCC-C6453N user manual To connect Alarm OUT, To connect the controller

Contents

Smart Dome Camera Overview English Overview FCC Statement Important safety instructions Contents Features What’s Included At a Glance CameraFrame SET Preparing Installation Installation Screw Fixing Hole Diagram Insert the cable into the Frame SET, and close the Adaptor Protective Tape from on the lens Button Frame SET Cover Camera Communication Protocol Setup Initial SetupCamera Address Setup Use SW606, SW605, and SW604 to specify the camera address Use pins #5, #6 of SW603 to set the baud rate Baud Rate SetupSetting RS-422A/RS-485 Termination Factory default is 9600 BPS RS-422A/RS-485 Full Duplex Organization Same address in the network Connecting with Other device Connecting to a monitorVideo terminal on the rear of monitor BNC Cable To connect Alarm To connect Alarm OUTTo connect the controller Connecting the adaptor cable Power SupplyAdaptor Board How to use the keyboard controller Using OSD iconsCamera will resume the last run operation Main Menu Profile  ITS Night Camera ID You can configure the general settings of the camera moduleCamera SET  Location Specify the display position of the camera ID Iris  Manual Adjust the iris level manuallyWith this, you can adjust the AGC level of a AGC Shutter MotionDNR SENS-UP XDR You can specify a recording mode according to the sceneFlickerless DAY/NIGHT Auto Switch or Auto Focus NeededSET-AUTO SET are not available White BAL DAY/NIGHT Display P/T Zoom SpeedDisplay Zoom Digital Zoom Reverse SyncAGC Color SUP POSI/NEGA Intelligent Video You can enable the motion detection and tracking functionsWhen multiple motions continue arbitrarily Advanced Privacy Zone ResolutionAlarm OUT Display Preset Select the preset number Select Position and adjust PAN Auto SET Auto Pan SetupSettings so define them again after the operation You can set the Auto PAN, PATTERN, and Auto Play Position Direction Left Endless OFF Speed Pattern Setup Scan SetupSelect the Start and move the camera using pan/tilt/zoom Auto Play Setup ~ 511 for Preset Zone SET You can set the north direction and the zone coverageSelect Main MENU-ZONE SET Alarm SET Select Main MENU-ALARM SET  Auto SET Sets the pattern and scan Clock SET Other SET OSD Color Factory DefaultsPassword Proportional P/T You can check the system information CommunicationSystem Info Select Main MENU-SYSTEM Info Language You can set the language of the user interface Shortcut Keys Function Key Specifications Manual Pan Speed 0.01˚~ 180˚/sec Preset Pan Speed 600˚/sec, maximumDescription PAN range 360˚Endless Tilt range -6˚~186˚ Product Appearance 00890A-NASCC-C6453N-ENG.indb 2009-08-05 오후