Installation
❚Before installation
THINGS TO KEEP IN MIND DURING INSTALLATION AND USE
•Do not disassemble the camera on your own.
•Always be careful when handling the camera. Do not strike the camera by your fists or shake it. Please be careful not to be careless when storing and operating it.
•Do not place or operate the camera in any wet environment such as rain or wet surfaces.
•Do not clean the camera with rough sandpaper. Please always use a dry cloth when cleaning it.
•Put the camera in a cool area free from direct sunlight. Otherwise, the camera may be damaged.
•Power adaptor: 24V AC, 3.0A
•If the camera is installed or rebooted after a power failure under 32°F temperature condition, frost may appear on the DOME cover. Also, PTZ initial error and bad image quality may be displayed under 14°F.
•After the problems, the recovery will be performed as following:
(Conditions: No wind and under
1 It is possible to defrost the DOME cover within 3 hours after the power on.
2 For PTZ initial error, reboot will be executed every 10 minutes and the camera will work normally within 3 hours after the power on.
※ If PTZ error occurs after the initial boot, the message shown below will be displayed. "WARMING UP NOW...", "PLEASE WAIT 10 MINUTES."
3 For bad image quality, the camera will work normally within 3 hours after the power on.
❚Initial setting
Setting up the Address of Smartdome
For the Address Setup of Smartdome, use “SW902”, “SW903”, and “SW904”.
You can set the address from 0 to 255. Set up the address digit for 100 with “SW902”, for 10 with “SW903”, for 1 with “SW904”.
For example, if the camera address is “1”, you can setup as follows.
SW902 SW903 SW904
