Connection
Lens
Lens is not supplied with this camera. Purchase a lens suitable for your environment. This camera accepts auto iris lens, both C- and
•If the lens is stained with fingerprint or something, the image quality might be poor.
•It is recommended to use a high quality lens to improve the image quality under low illumination.
Installing Auto Iris Lens
1.Peel the end of lens cable outer cover approximately 8mm.
approx.8mm
2.Peel the end of the cable inner cover approximately 2mm.
approx.2mm
3.Remove the cover from the connector pin supplied, and solder the lens cable to the connector pin as shown below.
•Video type : | •DC type : |
| Cover |
No.1 Pin … Red (Power source) | No.1 Pin … Damping - |
| Lens cable |
No.2 Pin … N. C | No.2 Pin … Damping + | No.3 Pin |
|
No.3 Pin … White (Video signal) | No.3 Pin … Drive + | Connector | |
No.4 Pin … Black (GND) | No.4 Pin … Drive - | No.1 Pin |
|
| No.4 Pin | ||
|
|
| |
|
|
| No.2 Pin |
4.Remove the protecting cap, and attach the lens into the camera by turning clockwise.
5.Connect the lens plug to the auto iris connector on the rear of the camera.
6.Set the DC/VIDEO selection switch to DC or VIDEO according to the type of the lens.
12 | COLOR CCD CAMERA | COLOR CCD CAMERA | 13 |
