Quick Start:
After initialisation, the Language selection screen will be displayed.
By using the LEFT/RIGHT keys, you may select the different menu languages available. Once you have selected the desired menu language, press OK to continue with
Select Menu Language
English |
After selecting the menu language, the receiver will display the Channel Tuning Menu: (Menu, Channel Setup, OK)
| LNB |
|
| A1 |
|
| |||
| Preset |
|
| Setup Satellite |
|
| |||
Preset Entry: | Satellite |
|
|
|
|
|
| ||
|
|
|
| Hotbird – 13.0E |
|
| |||
|
|
|
|
|
|
| |||
Move the cursor to highlight the “Satellite” box and | Frequency |
|
|
|
|
|
| ||
|
| 11720 |
|
|
| ||||
Sym. Rate |
|
|
|
|
| ||||
|
| 27500 |
|
|
| ||||
use the LEFT/RIGHT keys to scroll through the pre- | Polarity |
|
| Hor 18v |
|
| |||
FEC |
|
|
|
| |||||
stored satellites. For example, if your dish is aimed |
|
| 3/4 |
|
|
| |||
|
|
|
|
|
|
|
| ||
at the Astra satellite, when Astra is selected, you |
|
|
|
|
|
|
|
| |
should see both signal meters reading a good signal | Snaigl Found |
|
|
| Signal | ||||
level. The receiver will then prompt you to press OK |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| ||
to start tuning to all the channels on Astra. |
|
|
|
|
|
|
|
| |
| FTA |
| Off |
| Data | ||||
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||
(See next page) |
|
|
|
|
|
|
|
| |
Network | Bouquet | PIDs | |||||||
| |||||||||
|
|
|
|
|
| ||||
| Use |
| to change Satellite | ||||||
Note: |
|
|
|
|
|
| |||
F1 – Preset |
|
| F2 Mode | ||||||
1.If you wish to only tune to a specific Network or Bouquet of channels, move the cursor to highlight the “Bouquet” box and use the LEFT/RIGHT keys to scroll through the
2.If you only wish to download
Provided your dish is installed correctly and aligned to the relevant satellite, both the Signal and Data bars should display a GREEN bar which denotes the following:
The first bar shows the actual satellite SIGNAL strength
You should see a GREEN bar showing your satellite signal is medium to good. If it is RED, this normally indicates that either your dish/LNB
The second bar shows the quality of the DATA received
This GREEN bar indicates the DATA INTEGRITY of the signal received. If the bar is RED, this indicates that the DATA received is unreliable. This could cause the picture to break up, or disappear completely.
Note: If “No signal found” is displayed, check that the values entered are correct and are valid for the satellite your dish is installed for. (Please also refer to the “Advanced Users” and “Trouble Shooting” section to check that your LNB settings are correct).
Manual Entry (see also “Advanced User Guide” ):
(See the “Advanced User Guide” section for more information on manual entry and other tuning options other than Auto
8
