Samsung SNB-7000 Connecting with Other Device, Connecting to the monitor, Ethernet Connection

CONNECTING WITH OTHER DEVICE

		SD CARD				AUDIO OUT	AUDIO IN	Monitor
					SD	SYSTEM POWER
VIDEO						RESET
	1	2	3 4 5 6		NETWORK
1	: ALARM IN			4 : GND	ACT	LINK	AC 24V
2	: ALARM OUT			5 : RS-485+
						GND	DC 12V
3	: ALARM COM 6 : RS-485-

Power

Ethernet

Connecting to the monitor

Connect the video out port of the camera to the video input port of the monitor.

M In the initial installation of the camera, you can connect the camera to the monitor for checking the connection status.

You can set the video output type to either NTSC or PAL. (page 46).

Ethernet Connection

Connect the Ethernet cable to the local network or to the Internet.

Power Supply

Use the screwdriver to connect each line (+, –) of the power cable to the corresponding power port of the camera.

J 	Be careful not to reverse the polarity when you connect the power cable.
	You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
 If PoE and DC 12V are both applied, this camera will get supplied with power from PoE.
	Please make sure the monitor and camera are turned off when connecting them.

● INSTALLATION & CONNECTION

English _19