Rear

1

2

6

1Audio Out

2Audio In

3SDHC Memory Card Slot

4System, SD, and Power Indicators

5I/O Port

6Reset Button

3

4

7

8

5

For outgoing audio signals.

For incoming audio signals.

This is where you insert your SDHC memory card.

These indicators provide system, SD, and power status information.

Used to connect the camera to an external device.

A_IN 1 and 2: These are alarm in ports.

GND: This is the GND port.

A_OUT 1 and 2: These are alarm out ports.

NOT USED: This port is not used.

Reverts all camera settings to their default.

When it is pressed for 3 seconds, the system indicator goes out and the system reboots.

When the camera is reset, connection is possible only after the basic network settings (IP address, subnet mask, gateway, etc.) have been configured again using the IP installer program.

06_ Preparation