Desktop mounting
1.Place the camera in a desired position
on the surface.
2.Adjust the camera’s shooting angle as appropriate.
n` Do not put excessive force. Otherwise, it may cause damage to the camera.
` If you use the camera in contact with the base unit, this may cause noise on the video. It is advisable to use the camera in a 5º to 10º tilt.
3.Connect the power
cable.
n` When done, remove the protective film from the lens.
Wall mounting
1.Use a
n` Youincluded)can use the screws to tighten the camera. (not
`The
used once.
` Keep the installation surface clean before attaching the
Otherwise, the adhesive force may be deteriorated, causing a fall of the camera.
2.Fit the protruding points (x2) of the bracket into the corresponding holes of the camera before turning clockwise to fix the camera.
02