Phone Installation
Installing the Base Set
DC 12V 500mA
�When you have finished installing the base set, press“On Hook ”button and check for a dial tone.
�If you cannot hear a dial tone, then check both the power and phone line connections.
�This product works for 220V.
Installing theRemote Set
DC 12V 500mA
�Place the remote set on the charger and check if the lamplight is on.
�Press the call button and check for a dial tone.
�If you cannot hear the tone, check the installation.
To turn on / off the power
� To turn on the power: Press | button (hold for more than 2 seconds) until | |
you begin to hear the beeping sound. |
| |
� If it does not turn on when you press | button, then you probably |
need to recharge the remote set. It should then automatically turn on. Please recharge the battery for 24 hours before using it.
� If you do not charge the battery for at least 6 hours, then in order to protect it, the battery must be fully charged or it will stop operating.
�To turn off the power: Press buttons (hold for more than 3 seconds) until
Connect the phone line.
Connect the power plug to 220V.
Connect the power plug to 220V.
Loading the battery to the remote set |
| Installation& | ||
Open the | Place the | Rearrange the | Close the | |
1 battery cover. | 2 battery as | 3 line by setting | 4 battery cover. | Preparation |
| shown in the | the battery as |
| |
| picture. | shown in the |
| |
|
| picture. |
| |
|
|
|
|
How to use the battery
● Charge the battery for approximately 24 hours before using.
● Always remove the battery from the remote set, when you are not using it for an extended period.
● It is best to charge the battery until you see
the ( ) sign on the screen.
Battery life
● The battery life has a
purchase.
● As time goes by, there will be a reduction in the battery's power. When battery's power capacity is reduced by half, purchase a new battery and replace it.
●Please contact your local Samsung Electronics Service Center on how to purchase and replace the battery.
9
you hear the beeping sound.
10