Pendant Type Installation
STH- | 1. Assembling Flange and Ceiling Exposed Mount |
| |
380PO/370PO/370PI/360PO |
| ||
Wind sealing tape around the barrel of the screw taps, and then secure the | |||
| |||
| securely to the mount with the enclosed screws. |
| |
| Alignment Directions | Knob | |
2.Opening Hinged Door
Open the hinged door at the bottom of the housing.
Hold the knob on the hinged door to open.
3.Assembling Mount and Flange
First hook the safety cable on the mount, and then fit the housing into the fixture groove on the bracket as shown in the picture. Once the housing is safely attached to the bracket, secure the housing with the enclosed screws.
CLOSE
Pendant Type Installation
Notes
• Do not connect the camera to a power outlet until the installation is complete. Supplying power in the middle of the installation may cause fire or damage the product.
4.Wiring Terminal Cables
Connect the cables to the terminal block on the hinged door. Once the wiring is successful, close the hinged door.
✽For the location of the wiring pins, please refer to the “Camera Wiring Diagram” on Page 12.
5.Setting Up Camera DIP Switches
DIP switches for communication and ID protocols are located on the bottom of the camera. For the switch settings, refer to the appendix of this manual.
ID(SW1)
Protocol(SW2)
18 SPEED DOME CAMERA ACCESSORIES | SPEED DOME CAMERA ACCESSORIES 19 |
