ESC v
[Name] | Transmit paper sensor status. | ||
[Format] | ASCII | ESC | v |
| Hex | 1B | 76 |
| Decimal | 27 | 118 |
[Description] | Transmits the current paper sensor status. | ||
∙When DTR/DSR control is selected, the printer transmits only 1 byte after confirming that the host is ready to receive data (DSR signal is SPACE).
∙If the host computer is not ready to receive data (DSR signal is MARK),
the printer waits until the host is ready. When XON/XOFF control is selected , the printer transmits only 1 byte without checking the DSR signal.
∙This command is executed when the data is processed in the receive buffer. Therefore, there may be a time lag between receiving the command and transmitting the status, depending on the receive buffer status.
∙The status to be transmitted is shown in the table below.
∙This command is available only with a serial interface, and is ignored with
a parallel interface.
Bit | Off/On | Hex | Decimal | Function |
| Off | 00 | 0 | Paper roll end sensor. Paper is present. |
0,1 | On | 03 | 3 | Paper roll end sensor. Paper is not present. |
| Off | 00 | 0 | Paper roll end sensor. Paper is present. |
2,3 | On | 0C | 12 | Paper roll end sensor. Paper is not present. |
4 | Off | 00 | 0 | Not used. |
5,6 | - | - | - | Undefined. |
7 | Off | 00 | 0 | Not used. |
GS I n
[Name] | Transmit printer ID. |
|
| |
[Format] | ASCII | GS | I | n |
| Hex | 1D | 49 | n |
| Decimal | 29 | 73 | n |
| [Range] | 1 ≤ n ≤ 3, 49 ≤ n ≤ 51 |
| ||
| [Description] | Transmits the printer ID specified by n as follows: | |||
|
|
|
|
|
|
n |
| Printer ID |
| Specification | ID (hexadecimal) |
1, 49 |
| Printer model ID | 0DH | ||
|
|
|
|
|
|
2, 50 |
| Type ID |
| See table below. |
|
3, 51 |
| ROM version ID | ROM version |
| |
36
