_the Clock Automatically
9 Pressthe ENTER button.
Press the A or • button to select On or Off, then the ENTER button. The message Select the time zone where you are located, is displayed.
10Press the _. or T button to highlight the time zone for your local area. Press the ENTER button.
If clock is not automatically set, see pages 18~19 to set the clock.
11The message Enjoy your watching, is displayed. When you have finished, press the ENTER button.
Even if the ENTER button is not pressed, the message will automatically disappear after several seconds.
If you want to reset this feature...
1Press the MENU button to display the menu.
Press the A or _'button to select Setup, then press the ENTER button.
2Press the ENTER button to select Plug & Play.
For further details on setting up options, refer to the page 10. The Plug & Play feature is only available in the TV mode.
Memorizing the Channels
Your TV can memorize and store all of the available channels for both air and cable channels. After the available channels are memorized, use the CN _*, and CH V button to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels(automatic) and adding or deleting channels(manual).
Selectin- the Video Si
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV(i.e. an air or a cable system).
1Press the MENU button to displaythe menu.
Press the A or T button to select Channel, then press the ENTER button.
2Press the ENTER button select Antenna.
Press the A or _'button to select Air or Cable, then press the ENTER button.
Channels in Memor_
3Press the A or _'button to select Auto Program, then press the ENTER button.
4Press the A or T button to select the antenna connection, then press the ENTER button. Air: "Ai¢ antenna signal.
Cable: "Cable" antenna signal.
Air+Cable: "Air" and "Cable" antenna signals. If you selected "Air", then go to step 7.
5Press the A or _'button to select Cable, then press the ENTER button. The cable system menu is displayed.
6Press the _i button, then the A or T button to select the cable system for analog and
digital channels respectively. Press the
If you have Digital cable, select the signal source for both Analog and Digital. STD, HRC, and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal source has been selected.
7 After all the available channels are stored, the Auto Program menu reappears.
You can also press the AUTO PROG. button on the remote control to bring up the Auto Program menu.
