Samsung UE40S870XSXZG manual Network Setup Samsung Auto Configuration, Network Setup PBC WPS

Notice

The picture may appear corrupted or have static for some channels when the TV is connected to the Samsung Wireless LAN Adapter. In such a case, establish a connection using one of the following methods or connect the Samsung Wireless LAN Adapter using a USB cable in a place that is not affected by radio interference.

Method 1		Method 2
Connect using the USB right angle adapter	Connect via an extension cable
	✎✎The Samsung Wireless LAN Adapter should be
	installed in an interference-free area in order to
	avoid interference between the adapter and tuner.

04Features Advanced

or

Network Setup (Samsung Auto

Configuration)

This function is available in APs (Access Points) that support Samsung Auto Configuration. If your AP does not, you can connect through PBC (WPS), auto, or manually.

✎✎This function is available when SWL(Samsung Wireless Link) is set to Off.

✎✎You can check for equipment that supports Samsung Auto Configuration on www.samsung.com.

How to set up using Samsung Auto Configuration

1.Place the AP and TV next to each other and turn them

on.

✎✎ Because the booting times of applications differ, you may have to wait for approximately 2 minutes.

✎✎ If the LAN cable connected the WAN port of AP during Samsung Auto Configuration, you are able to complete until internet connection test. If you do not connect, Samsung Auto Configuration will check only device connecting of AP (Not check internet).

2.After 2 minutes, connect the Samsung Wireless LAN Adapter to the TV. When the Samsung Wireless LAN Adapter is established, the pop-up window appears.

3.As soon as a connection is established, place the AP in parallel with the Samsung Wireless LAN Adapter giving a gap no larger than 25cm.

4.Wait until the connection is automatically established. ✎✎ If Samsung Auto Configuration does not connect your TV to your AP, a pop-up window appears

on the screen notifying you of the failure. Reset the AP, and then try again. If the connection fails again, choose one of the other connection setup methods, PBC (WPS), auto, or manual.

5.After the connection is established, locate the sharer at

the desired location.

✎✎ If the AP settings have been changed or it is the first time you use the new AP after purchase, you need to set up again beginning from Step 1.

Network Setup (PBC (WPS))

How to set up using PBC (WPS)

If your router has a PBC (WPS) button, follow these steps:

1.Connect your TV to Samsung Wireless LAN Adapter as described in the previous section.

2.Turn on your TV, press the MENU button on your remote, use the ▲ or ▼ button to select Setup, and then press the ENTEREbutton.

3.Use the ▲ or ▼ button to select Network in the Setup menu, and then press the ENTEREbutton.

4.On the Network screen, select Network Type.

5.Set Network Type to Wireless.

6.Select Network Setup. The Network Setup screen appears.

English 33