Operating the cleaner

Installing the robotic vacuum cleaner

Instalation order1.Turning the Power Switch on or off

To use the robotic vacuum cleaner, you must turn on the Power Switch at the bottom of the main unit.

2.Installing the Charger

To charge the robotic vacuum cleaner, you must first install the charger.

Since the battery is discharged when the product is purchased, you must fully charge the battery before use.

3. Charging the Battery

You should charge the battery completely before using the robotic vacuum cleaner.

4.Setting the Time

You should set the time to use the scheduled and daily cleaning options.

5.Installing the VIRTUAL GUARD

You can confine the robotic vacuum cleaner to a particular section by using Fence (virtual wall) mode or clean several sections one by one using Guard (virtual door) mode.

6.Attaching a mop

Attach the mop to the bottom of the cleaning robot.

Turning the Power Switch on or off

To use the robotic vacuum cleaner, you must turn the

Power Switch on.

If you turn the Power Switch off, all settings will be reset.

1. Turn over the main unit and turn the Power Switch on.

- If the icons are not turned on, it indicates that the battery charge is depleted. In this case, dock the robotic vacuum cleaner to the charger station after turning the Power Switch on.

- The configured time may be different from the current time. If the configure time is incorrect, set the time to the current time.

✽If no key is pressed for approximately 5 minutes after turning the power on, the power is automatically cut to prevent the battery discharging. To turn the power on again, press and hold the power (Run/Stop) button on the main body or on the remote control for a short while.

If the Power Switch is turned off, the robotic vacuum cleaner will not be charged CAUTION even if it is docked with the charger station.

20_ Operating the cleaner