Notes and cautions
Charging
Note
▶▶If the battery overheats during charging, it may take longer to charge.
▶▶When automatic charging is not working, please check the followings.
––Turn the emergency switch (on the bottom of the vacuum cleaning robot) off and on again.
––Unplug the charger's power plug and then plug it back on.
––Check whether there is any foreign matter in the charge pins clean the vacuum cleaning robot and the charge pins of the charger with a dry cloth or rag.
––Check for any obstacles such as reflective objects, chairs, etc. near the charger.
▶▶If the vacuum cleaning robot is left detached from the charger, the battery will drain naturally.
––Try to keep the vacuum cleaning robot being charged on the charger. (Turn off the emergency switch and leave the charger unplugged when planning to leave the house for long periods of time by going on a business trip or vacation, etc., )
In use
Note
▶▶The vacuum cleaning robot may get caught on thresholds, etc. during cleaning.
––To restart operation, shut off the emergency switch, move the vacuum cleaning robot to an area where it can move easily and then turn on the power again.
▶▶The vacuum cleaning robot cannot completely clean areas it cannot enter, such as corners, between the wall and sofa, etc.
––Please use another cleaning tool to clean them regularly.
▶▶The vacuum cleaning robot cannot vacuum clumps of dirt, so some may remain on the floor after cleaning.
––Please use another cleaning tool to clean them regularly.
▶▶If the vacuum cleaning robot is turned off, power cannot be turned on by the [Power] button of the remote control. Press and hold the [Start/Stop] button on the vacuum cleaning robot.
▶▶If the battery becomes low during Auto/Max clean mode, the vacuum cleaning robot will recharge and finish cleaning the remaining area after recharging. (Repeat cleaning frequency: 1 time)
▶▶You cannot select and execute Max/Manual clean mode while charging.
▶▶Do not unnecessarily move the vacuum cleaning robot or press buttons while it is in Auto/Max clean mode. It assumes that cleaning is complete and starts cleaning again from the beginning.
Cleaning and maintenance
Note
▶▶If you washed the dustbin and filter with water
––Dustbin: Completely wipe out the water.
––Filter: Completely dry it in a shade before use.
Caution
▶▶Watch your finger when attaching or detaching the filter, since they may get stuck in the dustbin's intake.
▶▶To avoid blockages by foreign matter, do not let toothpicks, cotton swabs etc. from being vacuumed by the vacuum cleaning robot.
▶▶If it is difficult to remove foreign matters from the Power brush, contact a service center.
