Automatic charging
When the battery indicator blinks during cleaning, POWERbot will return to the docking station to charge itself automatically.
Recharging
You may command POWERbot to recharge at the docking station while it is in cleaning process.
Low battery (Lo)
Manually charge POWERbot by placing it on the docking station.
Steps to take if recharging is not being executed
Check the installation status of the docking station when:
ffdocking station is located in a place where POWERbot cannot easily access
ffdistance of the docking station and POWERbot is over 5 m apart
Manually charge POWERbot when:
ffdocking station is located in a corner ffbattery is fully exhausted
ffPOWERbot is stuck by obstacles (furniture etc.)
ffPOWERbot can't climb threshold near docking station (Height of the threshold that POWERbot can climb: about 2.0 cm and below)
ffBattery indicator blinks and "Lo" is displayed
ffPOWERbot is set on Spot clean or Manual clean mode