LEVELLING (TypeB)
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.
•Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure.
•Place the machine more than 10cm away from the wall.
•Adjust the legs on feet
for levelling .
Loosen Lock
1. Adjust the side horizontally first and the front
in same direction ❷ next.
2. If the thread is not within the limit, adjust the height of
the legs.
CONNECTING THE WATER SUPPLY HOSE
1.Remove the adaptor from the water supply hose.
hh
5.Connect the other end of the water supply hose to the inlet water valve at the back of the washer.
Screw the hose clockwise all the way in.
2.First,using a "+" type |
|
|
| |
screw driver, loosen the |
|
|
| supply hose to the inlet water valve |
four screws on the adaptor. | h |
|
| at the top of the washer. |
Next,take the adaptor and |
|
| Screw the hose clockwise all the way in. | |
turn part(b) following the |
|
|
| |
arrow for gap about 5mm |
|
|
| |
between them. |
|
|
| |
3. Connect adaptor to the | h | h |
| If the water tap is a screw type,assemble |
water tap by tightening |
|
| h | a water supply hose that fits to the |
the screws firmly. |
|
| ||
|
| tap as shown. | ||
Then, turn part (b) |
|
| ||
|
|
| ||
following the arrow and | h | h |
| |
put (a) and (b)together. |
| |||
4.Connect the water supply | NOTICE After completing connection, if water leaks from the hose, | |||
hose to the adaptor. Pull down |
|
| then repeat the same steps. | |
the part (c) of the water supply |
|
| ||
|
| Use the most conventional type of faucet for water supply. | ||
hose .When the part (c)is released, |
|
| ||
| h | In case the faucet is square or too big,remove the spacing | ||
the hose is automatically |
| |||
| ring before inserting the faucet into the adaptor. | |||
connected to the adaptor |
| |||
|
|
| ||
making a 'click' sound. |
|
|
| |
9
