Problem |
| Action |
|
|
|
| |||
|
|
|
|
|
|
| |||
| • Plug the power cord into a live electrical outlet. |
|
|
| |||||
| • Check the fuse or reset the circuit breaker. |
|
|
| |||||
|
|
| |||||||
| • | Close the door and press |
| Start/Pause to start the washing | |||||
|
| ||||||||
|
| machine. For your safety, the washing machine will not |
| ||||||
|
| tumble or spin unless the door is closed. |
|
|
| ||||
| • | Before the washing machine starts to fill, it will | make a series | ||||||
|
| of clicking noises to check the door lock and does a quick |
| ||||||
Stops. |
| drain. |
|
|
|
| |||
• There may be a pause or soak period in the cycle. Wait briefly | |||||||||
| |||||||||
|
| and the washing machine may start. |
|
|
|
| |||
| • | Make sure the mesh filter of the water supply hose at the | |||||||
|
| water taps is not clogged. Periodically clean the mesh filter. | |||||||
| • | If the washing machine is not supplied with sufficient power, | |||||||
|
| the washing machine temporarily will not drain or spin. As | |||||||
|
| soon as the washing machine regains sufficient | power, it | will | |||||
|
| operate normally. |
|
|
|
| |||
|
|
|
|
|
|
|
| ||
| • Fully open both taps. |
|
|
|
| ||||
| • Make sure the temperature selection is correct. |
|
|
| |||||
| • Make sure the hoses are connected to the correct taps. Flush | ||||||||
|
| water lines. |
|
|
|
| |||
| • Make sure the water heater is set to supply a minimum 120 | ||||||||
|
| °F (49 °C) hot water at the tap. Also, check the water heater | |||||||
|
| capacity and recovery rate. |
|
|
|
| |||
Fills with the wrong | • | Disconnect the hoses and clean the mesh filter. The | mesh | ||||||
| filter may be clogged. |
|
|
|
| ||||
water temperature. |
|
|
|
|
| ||||
• | While the washing machine fills, the | water temperature | may | ||||||
| |||||||||
|
| change as the automatic temperature control feature checks | |||||||
|
| incoming water temperature. This is normal. |
|
|
| ||||
| • | While the washing machine fills, you | may notice just | hot and/ | |||||
|
| or just cold water going through the dispenser when cold or | |||||||
|
| warm temperatures are selected. This is a normal function | |||||||
|
| of the automatic temperature control feature as the washing | |||||||
|
| machine determines the water temperature. |
|
|
| ||||
|
|
|
|
|
|
| |||
| • Use the High or Extra High spin speed. |
|
|
| |||||
Load is wet at the | • | Use high efficiency (HE) detergent to reduce oversudsing. | |||||||
• Load is too small. Small loads (one or two items) may become | |||||||||
end of a cycle. | |||||||||
| unbalanced and not spin completely. |
|
|
|
| ||||
|
|
|
|
|
| ||||
| • Make sure the drain hose is not kinked or clogged. |
|
| ||||||
|
|
|
|
|
|
|
|
| |
Troubleshooting
English 57
