Troubleshooting
Troubleshooting
Problem | Action |
|
|
| • Plug the power cord into a live electrical outlet. |
| • Check the fuse or reset the circuit breaker. |
| • Close the door and press or tap Start/Pause to start the |
| washing machine. |
| For your safety, the washing machine will not tumble or spin |
| unless the door is closed. |
| • Before the washing machine starts to fill, it will make a series |
| of clicking noises to check the door lock and does a quick |
Stops. | drain. |
| • There may be a pause or soak period in the cycle. Wait briefly |
| and the washing machine may start. |
| • Make sure the mesh filter of the water supply hose at the |
| water taps are not clogged. Periodically clean the mesh filter. |
| • If the washing machine is not supplied with sufficient power, |
| the washing machine temporarily will not drain or spin. As |
| soon as the washing machine regains sufficient power, it will |
| operate normally. |
|
|
| • Fully open both taps. |
| • Make sure the temperature selection is correct. |
| • Make sure the hoses are connected to the correct taps. Flush |
| water lines. |
| • Make sure the water heater is set to supply a minimum |
| 120 °F (49 °C) hot water at the tap. Also, check the water |
| heater capacity and recovery rate. |
| • Disconnect the hoses and clean the mesh filter. The mesh filter |
Fills with the wrong | may be clogged. |
water temperature. | • While the washing machine fills, the water temperature may |
| change as the automatic temperature control feature checks |
| incoming water temperature. This is normal. |
| • While the washing machine fills, you may notice just hot and/ |
| or just cold water going through the dispenser when cold or |
| warm temperatures are selected. |
| This is a normal function of the automatic temperature |
| control feature as the washing machine determines the water |
| temperature. |
|
|
46 English
|
|
|
|
2016/4/1 13:34:51 | |||
|
|
|
|