Step 3: Add the Vise Assemblies to the Monitor Brackets:
NOTE: Do not overtighten the
Place the Vise Assembly (F) into the Monitor Bracket (E) so that the two Jaws point toward the set of 1” diameter holes and the Allen Bolt is facing away from the television. Place a 2” Carriage Bolt (L) through the square hole in the side of the Monitor Bracket, and the Vise Assembly; then, through the square hole in the other side of the Monitor Bracket. Thread and tighten a
Vise Detail
Diagram 3
Jaws
1” Dia. | F |
Hole |
Allen
Bolt
L
M
E
Step 4: Attach the Arm Assembly to the Television
Align each Vise Assembly (F) so that a 1” Diameter Tube (D) will pass through the 1” round hole in the Monitor Bracket (E) and between the jaws of the Vise Assembly. Insert a 1” Diameter Tube through the top hole in the first Monitor Bracket. Repeat this step for the Bottom hole in the same Monitor Bracket. See Diagram 4a for assistance.
Diagram 4a
DE
F E F
Step 4: Attach the Arm Assembly to the Television (Continued on next page.)