Step 4: Attach the Arm Assembly to the Television (Continued)
CAUTION: The 1” Diameter Tubes (D) must extend beyond the outside edges of both Monitor Brackets (E) and the Allen Bolts in all 6 Vise Assemblies (F) must be tightened. Failure to do this will result in an installation that unstable and may result in property damage and/or personal injury.
Position the Arm Assembly (B) so the hook shaped tab shown in Detail View of Diagram 4b is on the top. Line up the two 1” diameter holes in the Monitor Bracket (E) at the other end of the Arm Assembly with the with the 1” Diameter Tubes (D). Push the 1” Diameter Tubes through the bracket on the Arm Assembly; then, through the other Monitor Bracket. Make sure the Vise Assemblies (F) on both the Arm Assembly and the second Monitor Bracket are aligned so that the 1” Diameter Tubes will pass between the jaws.
NOTE: Do not
(D) must not be able to move from
Once the 1” Diameter Tubes are in place, tighten the allen bolts on the 4 Vise Assemblies in the two Monitor Brackets with the 3/16 Allen Key (K) to lock the television to the mount. Slide the Arm Assembly into the desired position between the two Monitor Brackets (Sanus recommends Arm Assembly be centered between the Monitor Brackets) and tighten the two remaining Allen Bolts in the Vise Assemblies inside the Arm Assembly.
Detail View
F | Diagram 4b | Tab |
D
E
D 
B
E
F
Step 5: Attach the Wall Plate: Wood Stud installation only.
CAUTION: Do not overtighten the Lag Bolts. Tighten Lag Bolts (I) only until the Lag Bolt Washer (J) is pulled firmly against the Wall Plate (A). If there is a layer of drywall or other material, this drywall or other material may not exceed 5/8 inch [15.8 mm] in thickness. Failure to heed this caution may result in property damage and/or personal injury.
The Wall Plate (A) must be mounted to two wood studs at least 12” apart. Use a high quality stud sensor to locate two
Diagram 5
adjacent studs. Verify where the studs are located with an awl or thin nail.
A
Stud
holes are in the center area of the studs and level with each other. Use the Wall Plate as a template to mark the location of the second hole in each stud. Drill 2.5” deep holes using the 3/16” drill bit in the marked location. Attach the Wall Plate to the wall using four Lag Bolts (I) and four Lag Bolt Washers (J). Make sure the Wall Plate is oriented so the flat surface in the center of the plate is against the wall. See Diagram 5 for assistance.
I 
J
Drywall cut away
to show studs.
