PRECAUTIONS

CAUTION

THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE. TO

ENSURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS

OR ATTEMPT TO GAIN ACCESS TO THE INSIDE OF THE PROD-

UCT. REFER ALL SERVICING TO QUALIFIED PERSONNEL.

 

CLASS 1 LASER PRODUCT

CAUTION

LUOKAN 1 LASERLAITE

KLASS 1 LASERAPPARAT

DO NOT OPEN

RISK OF ELECTRIC SHOCK

 

AVIS: RISQUE DE CHOC ÉLECTRIQUE - NE PAS OVRIR.

 

-The apparatus shall not be exposed to dripping or splashing.

-Do not use where there are extremes of temperature (below 5oC or exceeding 35oC), or where direct sunlight may strike it.

-Because of the CD player’s extremely low noise and wide dynamic range, there might be a tendency to set the volume on the amplifier unnecessarily high. Doing so may produce an excessively large out- put from the amplifier which could damage your speakers.

-Sudden changes in the ambient temperature may cause condensa- tion to form on the optical lens inside the unit. If this happens, take out the disc, leave the unit for about 1 hour, and then proceed to operate.

- The system’s speakers use powerful magnets. Do not place time- pieces, credit cards, cassette tapes or video tapes, etc. near the speak- ers.

-Do not install this equipment in a confined space, such as a book case or built in cabinet.

-No object filled with liquids, such as vase, shall be placed on the ap- paratus.

-The rating label is located on the bottom of the unit.

IMPORTANT

If the plug supplied with this equipment is not suitable for the socket outlets in your home it should be cut off and replaced with the correct type.

Disposal of Plug

If the non rewireable plug is to be cut off, the removed plug should be disposed of carefully as there is a shock hazard should the plug be inserted into a live socket.

Replacing Fuse

The detachable fuse cover must be replaced after changing the fuse. Only a 3A fuse should be used and should comply with BS1362 and

should carry the ASTA mark .

The wires in the mains lead are coloured in accordance with the follow- ing code:

BlueNeutral

BrownLive

The wires in the mains lead must be connected to the terminals in the

plug as follows:

 

Wire colour

Plug terminal marking

Blue

N or Black or Blue

Brown

L or Red or Brown

Do not connect either wire to the earth terminal.

If the mains plug contains a fuse this should be 3A, if a plug without a fuse is used the distribution board fuse should not be greater than 5A.

The unit is not disconnected from the mains unless it is unplugged from the AC outlet.

-1-

Page 3
Image 3
Sanyo DC-MP9500 instruction manual Precautions, Disposal of Plug, Replacing Fuse