GETTING STARTED

CONNECTING CABLE SERVICE, RF ANTENNA, OR SATELLITE RECEIVER TO THE TV

RF Antenna

OR

VCR Back

Cable Service

OR

LCD TV Back

Satellite Receiver

 

Notes:

– If you do not have a cable box, connect cable directly to TV 75 ohm jack or VCR.

– If you do not have a VCR, connect signal directly to TV 75 ohm jack.

CATV FRANCHISE NOTE: Cable compa- nies, like public utilities, are franchised by local government authorities. To receive cable programs, even with equipment which is capable of receiving cable channels, the consumer must subscribe to the cable company’s service.

Operational Tip for Monitor Use:

If the TV is used as a monitor only, with a DVD player or some other type of external equipment, and no cable or antenna signal is available, the following setup is necessary:

Your TV is designed to automatically search for available channels. Therefore, the initial start up requires that you press the CH-UP (Channel ▲) key, enabling the TV to automatically go through the channel search process before you can operate the TV. After the initial channel search is completed, you must press the CH-UP (Channel ▲) key again to complete the channel search process. This may take several minutes.

After the channel search process is complete (2 searches), you can press the INPUT key on the remote control to use the TV as a monitor.

■TV will automatically select the correct Antenna mode for the type of Analog RF signal connected.

Use “Antenna Selection” in the Setup menu to change the Antenna Mode.

■TV will switch off automatically after 15 minutes if there is no signal reception (cable out or station not broadcasting).

Exception—When the Video mode is selected, the TV will not automatically switch off when signal reception has stopped for 15 minutes.

■If you move the TV to a new location, press the RESET key twice after connecting the signal and turning on the TV.

6Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032