Sanyo DWM-2500 instruction manual Listening to Preset Stations, Number buttons Enter

Manual presetting

1.Tune in the station to be preset as described in “Automatic/ Manual Tuning”.

2.Press [PROGRAM/RANDOM]. “PGM” blinks.

PGM

ST

3.While “PGM” is blinking, press [PRESET +] or [- PRESET] to select the channel to be preset.

•The number buttons on the remote control can also be used.

•In this example, the channel is “9”.

PGM

ST

4.While “PGM” is blinking, press [ENTER].

•In this example, “103.1 MHz” FM station is preset on FM channel 9.

PGM

ST

ST

5. Repeat steps above to add more preset stations.

•When presetting a new station, the previous preset station is cleared.

Listening to Preset Stations

Preset tuning

1.Press [TUNE/BAND] to select FM or AM.

2.Press [PRESET +] or [- PRESET] briefly to select the desired channel.

•If using the number buttons, press the number button(s), then press [ENTER].

Preset scan tuning

1.Press [TUNE/BAND] to select FM or AM.

2.Press [PRESET +] for at least 1 second.

•The channel number appears.

•The preset stations are selected in sequence for approximately five seconds each.

3.Press [PRESET +] when the desired station has been selected. Preset scanning will stop.

When beat interference is heard

A high-pitched noise called “beat” is sometimes heard during reception of radio broadcasts.

If this occurs, while holding [n] down on the front panel, press [TEST] on the remote control to select “bc-A” or “bc-B”. Select the setting that gives the best results.

2

Number buttons

4

3

Number buttons

1

Enter

2

Changing the reception frequencies

It is not necessary to perform this procedure in the U.S. and Canada.

1.Select the band to be changed.

2.While holding [n] down on the front panel, press [PROGRAM/ RANDOM] on the remote control.

To return the original setting, repeat steps above.

AM: 520 ~ 1710 kHz (10 kHz steps)

522 ~ 1710 kHz (9 kHz steps)

FM: 87.9 ~ 107.9 MHz (200 kHz steps)

87.5 ~ 108.0 MHz (50 kHz steps)

-E37-